Table of Contents
Advertisement
24
Reset setpoint value
25
DPT_HVAC Status
28
Error external sensor
29
Actual setpoint
30
RHCC Status
31
Mode selection
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1 • Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
14
Technical Manual Glass Room Temp. Contr. SCN-RT1Gx.01
Parameter read in
DPT 1.001
Send controller status
-
Error message
DPT 1.001
Send setpoint
DPT 9.001
Send controller status
DPT 22.101
Select mode
DPT 20.102
receive
Controller resets
the setpoints to
the values which
are set in the
parameter
send
Controller sends
current state
send
Controller sends
state
send
Conntroller sends
current setpoint at
a read request
send
Controller sends
current state
receive/
Controller
send
switches between
operating modes
and sends the
current operating
mode if activated
Visu, Opereating
Object is always shown when
keys, Control unit
the controller is active
Visu, Display,
Object is always shown when
Diag osti ,...
the controller is active
Visu, Display,
Object is always shown when
Diag osti ,...
the controller is active
Visu, Display,
Object is always shown when
Diag osti ,...
the controller is active
Visu, Display,
Object is always shown when
Diag osti ,...
the controller is active
Visu, Operating
Communication object is
keys, Control unit,
permanently displayed when
Display,
the controller was activated.
Diag osti , ...
Via the pa a ete "e d status
o o je t
the sending of this object can
be activated. So this object can
be directly used by home
servers and visualizations.
ode sele tio ,
Advertisement
Table of Contents
