Operating Mode After Reset - MDT SCN-RT1GW.01 Technical Manual

Technical Manual Glass Room Temp. Contr. SCN-RT1Gx.01

6.3.2.7 Operating mode after reset

The following figure shows the available settings for the operating mode after reset:
Figure 11: Settings operating mode after reset
The following table shows the available settings for the operating mode after reset:
ETS-text
Operating mode after reset
Table 33: Operating mode after reset
This parameter defines the operating mode, which shall be adjusted after a bus power return:

Comfort with parameterized setpoint
After a bus power return, comfort is activated with the setpoint, which was set by the ETS.

Standby with parameterized setpoint
After a bus power return, standby is activated with the setpoint, which was set by the ETS
(Comfort-Setpoint – Standby reduction).

Hold old state and setpoint
The temperature controller calls the setpoint and mode, which was set before bus power
down.
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
44
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[default value]
 Comfort with
parameterized setpoint
 Standby with
parameterized setpoint
 Hold old state and setpoint
comment
Adjustment, which operating mode shall
be switched on after a bus power return