Technical Manual Glass Room Temp. Contr. SCN-RT1Gx.01
The following table shows the available settings for the LCD-Display:
ETS-text
Standby-Display at Day/Night
Change time between function
blocks
Time until Display changes into
standby
Shown functional blocks
Representation after standby
Show function buttons in
standby
Table 11: Display Settings
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
29
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
Dynamic range
[default value]
switched off
only actual temperature
only time
only outside temperature
actual temperature and
time
actual temperature and
outside temperature
time and outside
temperature
actual temperature and
outside temperature,
time
never-60s
[2s]
never-60s
[20s]
Temperature controller
Ventilation control
Temperature controller
and function
Temperature controller
and ventilation control
Ventilation control and
function
Temperature controller,
ventilation control and
function
Function
Temperature controller
Ventilation control
No
Yes
comment
defines the functional block, which is
displayed in standby
defines how long a functional block
(temperature, time or outside
temperature) is shown; is only kept if
the standby-mode shows more than
one functional block
defines the time between the last key
press and activating of the standby-
mode
defines the functional blocks, which can
be controlled via the display
defines the functional block, which is
called after a reset, only active blocks
can be chosen
defines if the buttons C/D should be
shown in the standby mode