2. Retard Roller Shaft Unit
1) Remove the retard roller.
2) Remove the right cover, left cover and
PCB unit.
3) Insert thin and flat head tools into the 2
fitting parts 1 and remove the roller
cover 2 .
Figure 3-309
4) Insert thin and flat head tools into the
small hole 2 of the 2 C shaped collars 1
and pull then out.
Note: Slightly press the C shaped collars when
pulling it out to prevent it from being
blown away.
Figure 3-310
COPYRIGHT © 2005 CANON ELECTRONICS INC.
5) Push and rotate the right and left shafts 1
6) Rotate the retard roller shaft unit 1 and
* Notes on assembly
CANON DR-2580C FIRST EDITION APR. 2005
CHAPTER 3 DISASSEMBLY/ASSEMBLY
to insert their edges into the inside of the
frame.
Figure 3-311
unhook the left and right fitting parts 2 .
Figure 3-312
Make sure if the retard roller smoothly
rotates after the completion of assembly.
3-13