Canon DR-2580C Service Manual page 107

2. Installation Procedure
The service mode software installation
procedure is described below. Do not install it
on the user's computer.
1) Power ON the computer for servicing and
start up the OS (Windows).
2) Set the DR-2580C setup disk supplied
with this machine.
3) Copy the "\Driver\Tools" folder in the
setup disk to one of the drives of the
computer for servicing.
Note: For how to install the software provided
with the DR-2580C, refer to the user
manual.
However, for the specifications, such as
the maximum number of documents that
can be scanned at one time, see the
computer system conditions described
in the user manual.
COPYRIGHT © 2005 CANON ELECTRONICS INC.
3. Starting Up and Exiting Service
mode is described below.
1)
2)
3)
4)
5)
the service screen.
CANON DR-2580C FIRST EDITION APR. 2005
CHAPTER 5 TROUBLESHOOTING
Mode
The procedure for starting up the service
Connect the computer for servicing with
the DR-2580C using a USB interface ca-
ble.
After powering ON the DR-2580C, power
ON the computer.
Open the installed "Tools" folder and start
up the "VBTool.exe" file. (See Figure
5-202.)
The password screen is displayed, so
after inputting the six characters "market,"
select [OK]. (See Figure 5-203.)
The service screen is displayed.
To exit the service mode, select [Close] in
.
Figure 5-202
Figure 5-203
5-3