Installing The Printer Driver; For Network Connection - MUTOH RJ-900X series Installation Manual

RJ-900X series INSTALLATION MANUAL
11 Check the printing condition
Check the print head condition after ink initial
filling1
11 Turn ON the power to the printer, and set A3
or larger sheet media or roll media1
111 Loading the media
21 Check that "Ready to Print" is displayed on
Operation panel1
31 Press the [Menu] key on the operation panel1
・ "*Menu* TestPlot >" is displayed on the opera-
tion panel
・ Operation panel shifts to the Setup menu display1
41
Press the [Enter] key on Operation panel 1
・ "TestPlot: SetupPlot" is displayed on the op-
eration panel
・ Display shifts to Test print menu1
51
Press the [Setting value +] key or [Setting
value-] key on the operation panel, select
"Nozzle check" and press the [Enter] key1
・ Perform the nozzle check printing1
RJ900XE-I-00
61 Check the print sample and confirm that the
checked points are blurred or missing1
71
If the nozzle check result indicates that the
checked points are blurred or missing, clean
the head1
・ Press the [Cleaning] key on the operation
panel for at least 2 seconds1
・ "Cleaning ** min" is displayed on the opera-
tion panel1
81
Start head cleaning1
NOTE
If print blurs or incomplete printing is not
z
fixed by one head cleaning, perform strong
cleaning1
If several head cleanings does not remove
z
print blur or incomplete printing, refer to the
following and perform required procedures1
Operation Manual "6 Troubleshooting"
91
Perform the nozzle check again, and confirm
the print head condition1
10
11

Installing the printer driver

1111

For network connection

This section explains how to connect to the
Internet (TCP/IP)1
11
Turn ON the power to the printer1
21
Set the IP address for the printer1
NOTE
For the procedure to set IP addresses, refer to
z
31615 Setting IP Addresses in the Operation
manual1
You can view the Operation manual from the
z
CD-ROM ( Drivers and Manuals CD-ROM )
included with the product1
The language preference screen is displayed
・
when you start the CD-ROM1Click the lan-
guage you want, and then click Viewing
the Operation manual on the next screen1
31
Insert the network interface cable connector
into the network interface connector located
on the back of the printer1
No1 Name No1
1 Network interface cable 2 Network interface con-
nector
41 Fix the network interface cable to the cable
clamp1
No1 Name No1
1 Network interface cable 2 Cable clamp
51
Connect the another network interface cable
connector to the PC1
61
Turn ON the power to the PC1
Name
Name