AIRTRONICS MT-S User Manual page 34

MT- S
Telemetry System with Sanwa Synchronized Link Support
2.4GHZ FH4T RADIO SYSTEM USER'S GUIDE
POINT AUX MENU ( POINT AUXILIARY )
Choosing the Key Option (Key Assign Function), Continued:
1) Press the ENTER key, then press the UP or DOWN keys to highlight KEY.
2) Press the ENTER key to open the KEY ASSIGN menu, then Assign AUX1 POINT or
AUX2 POINT to Auxiliary Switch Sw3 or a Trim Switch (Trim Switch Trm3). For more
information, see the KEY ASSIGN Menu section on pages 56 through 60.
Changing the Point Auxiliary Position Values:
The Point Auxiliary Position values determine the positions the Auxiliary 1 (Channel 3) or Auxiliary 2 (Channel 4) servos will move
when you cycle through the various Points.
1) From within the AUX SET menu, press the BACK key so the cursor is flashing over
Channel/Options.
2) Press the UP or DOWN keys to highlight AUX CH, then press the ENTER key to open
the AUX CH menu.
3) Press the UP or DOWN Keys to choose A1 POINT or A2 POINT, depending on which
Auxiliary channel you want to change the Point Auxiliary Position value for.
4) Press the ENTER key, then move the Auxiliary Switch (or Trim Switch) you've
programmed to control the Point Auxiliary function to highlight the Point Auxiliary
Position you want to change Point Auxiliary Position values for, either 1, 2 or 3.
5) Press the ENTER key, then press the UP or DOWN keys to change the selected Point
Auxiliary Position value. Increasing the value toward the High side (H) or Low side
(L) will cause the Auxiliary servo to travel to that specific position when you cycle the
Point Auxiliary function.
6) Press the BACK key, then repeat steps 4 and 5 to change the remaining Point Auxiliary Position values.
AUX CH POINT setting range is H100 to L100. The default setting for all three Points and both channels is 0. These
values are a percentage of Auxiliary servo travel.
Controlling the Point Auxiliary Function:
Auxiliary Switch Sw1 and Sw2 are not suitable for controlling the Point Auxiliary function. We suggest controlling the Point
Auxiliary function with Auxiliary Switch Sw3 or a Trim Switch. If you haven't already Assigned the AUX1 POINT or AUX2 POINT
function to one of these Auxiliary Switches, you should do that now. For more information, see the KEY ASSIGN Menu section
on pages 56 through 60.
1) Slide the Auxiliary Switch back and forth or press the Trim Switch forward
and backward to cycle the Auxiliary servo forward and backward through
the programmed Points.
If the servo moves the wrong direction, program the Point Auxiliary Position values opposite of what you currently
have (i.e. change from H50 to L50, etc.).
34
AUX