Setting Menu Overview; D/R Menu (Dual Rate) - AIRTRONICS MT-S User Manual

MT- S
Telemetry System with Sanwa Synchronized Link Support
2.4GHZ FH4T RADIO SYSTEM USER'S GUIDE

SETTING MENU OVERVIEW

To access the various SETTING menu Programming Menus, turn the transmitter
ON, then press the ENTER key to open the PROGRAMMING screen.
Press the UP or DOWN keys to highlight the SETTING menu, then press the
ENTER key to open the SETTING menu.
The following Programming Menus are available within the SETTING menu:
MENU
D/R
SPEED
CURVE
F/S
BASE
FUNC
D / R MENU ( DUAL RATE )
The Dual Rate function allows you to change the control authority of the Steering, Throttle High Side and Throttle Brake Side
by changing the amount of servo travel relative to control input. For example, by Increasing the Steering Dual Rate, you can
make the Steering servo travel more, which might prevent your model from pushing during turns. Alternately, if your model
over-steers during turns, you can reduce the amount of Steering Dual Rate. Adjusting Steering Dual Rate affects both Right
Side and Left Side steering equally, however, you are able to adjust Throttle Dual Rate on the Throttle High Side and Throttle
Brake Side independently.
IMPORTANT: Prior to programming the Dual Rate function, you should adjust the maximum Left and Right (or High and Low)
End Points. For more information, see the EPA Menu section on pages 25 and 26.
Changing the Dual Rate Percentage Values:
1) From within the SETTING menu, press the UP or DOWN keys to highlight the channel
you want to adjust the Dual Rate percentage value for, then press the ENTER key to
open the D/R menu. RATE 100% will be highlighted.
If the cursor isn't flashing over Channel/Options, press the BACK key.
IMPORTANT: Dual Rate percentage values cannot be changed for A1 (Auxiliary Channel 1) or A2 (Auxiliary Channel 2).
2) Press the ENTER key, then press the UP or DOWN keys to Increase or Decrease the
Dual Rate percentage value for the selected channel. When the Dual Rate percentage
value is Decreased, servo travel is Decreased. When the Dual Rate percentage value
is Increased, servo travel is Increased.
D/R RATE setting range is 0% to 100%. The default setting for all channels is 100%.
Adjust Steering, Throttle and Brake Dual Rates
Adjust Servo Speed in the Forward and the Return to Neutral Directions
Adjust Channel Adjustable Rate Control (ARC)
Program Fail Safe Settings and Receiver Battery Voltage Fail Safe
Adjust Channel Servo Reversing, Sub-Trim and End Points
Adjust Channel Trim, Anti-Lock Brake, Throttle Offset and Throttle Type
driving by Assigning these functions to a Trim Switch. In addition, the Dual
Rate function can be toggled ON and OFF while you're driving by assigning
this function to an Auxiliary Switch. For more information, see the KEY ASSIGN
Menu section on pages 56 through 60.
MENU DESCRIPTION
In the default configuration, Trim Switch Trm3 controls Steering Dual
Rate. Throttle and/or Brake Dual Rate can be changed while you're
SETTING
PAGE #
PG. 19
PG. 20
PG. 21
PG. 22
PG. 24
PG. 26
SETTING
19
Section Continued on Next Page