Vr Adjust Menu (Control Calibration) - AIRTRONICS MT-S User Manual

MT- S
Telemetry System with Sanwa Synchronized Link Support
2.4GHZ FH4T RADIO SYSTEM USER'S GUIDE
LCD MENU { LCD CONTRAST AND BACKLIGHT OPTIONS }
Changing the LCD Backlight On-Time:
The LCD Backlight On-Time determines how long the LCD Backlight will stay ON before turning OFF automatically.
1) From within the LCD menu, press the UP or DOWN keys to highlight LIGHT-TIME
10sec.
2) Press the ENTER key, then press the UP or DOWN keys to choose the desired LCD
Backlight On-Time value (in seconds).
If the Backlight Mode is set to ALWAYS or OFF, changing the LCD Backlight
On-Time value will have no effect.
LCD LIGHT-TIME setting range is 1 to 30 seconds. The default setting is 10 seconds.
VR ADJUST MENU { VARIABLE RATE ADJUSTMENT - CONTROL CALIBRATION }
The Variable Rate Adjustment function allows you to calibrate the operation of the Steering Wheel and Throttle Trigger End
Points and Neutral positions. Over time, it's possible that the End Points and/or Neutral positions of these controls may change
slightly. Being able to calibrate these controls ensures precise operation at all times. We recommend using the Variable Rate
Adjustment function as part of a periodic maintenance schedule.
IMPORTANT: After using the Variable Rate Adjustment function, you should double-check the End Point Adjustments of each
saved model. If the End Points have moved, they will need to be readjusted using the End Point Adjustment function.
The steps required to calibrate the operation of the Steering Wheel and Throttle
Trigger are the same. The example shown in this section details calibrating the
Steering Wheel.
Calibrating the Steering and Throttle Controls:
1) From within the SYSTEM menu, press the UP or DOWN keys to highlight the VR
ADJUST menu.
2) Press the ENTER key to open the VR ADJUST menu. STEERING < 0 > will be highlighted.
Depending on the current state of calibration, a value other than 0 may be
highlighted.
3) Press the UP or DOWN keys to choose which control you would like to calibrate, either
STEERING or THROTTLE.
4) With the Steering Wheel (or the Throttle Trigger) in the Neutral position, press the
ENTER key. NEUT POS < ---- > will be displayed.
5) Press the ENTER key a second time. A menu with several position indicators will be
displayed and OK will be displayed next to the NEUT POS value.
6) Move the Steering Wheel (or the Throttle Trigger) all the way in one direction, then
allow the control to return to Neutral. Move the Steering Wheel (or the Throttle Trigger)
all the way in the opposite direction, then allow the control to return to Neutral. A
series of values and Adjust ok? NO/YES will be displayed.
7) Press the UP or DOWN keys to highlight YES, then press the ENTER key. Executed will flash, indicating that the calibration
process is complete. If you want to cancel the calibration process for any reason, choose NO or press the BACK key.
8) If desired, repeat steps 3 through 7 to calibrate the remaining control, either STEERING or THROTTLE.
SYSTEM
SYSTEM
63