AIRTRONICS MT-S User Manual page 16

MT- S
Telemetry System with Sanwa Synchronized Link Support
2.4GHZ FH4T RADIO SYSTEM USER'S GUIDE
SETUP WIZARD ( CAR TYPE TEMPLATES )
Changing the Modulation Type, Channel Response Mode and Binding, Continued:
2) Press the UP or DOWN keys to highlight the desired channel you would like to change the Channel Response Mode for.
The following Channel Response Modes are available:
NOR - Use with any brand of Analog or Digital servos (Slowest Response Time).
SHR - Use with any brand of Digital servos only (Faster Response Time).
SSR - Use with Airtronics or Sanwa Super Response SRG Digital servos only (Fastest Response Time) - FH4T Only.
3) Press the ENTER key, then press the UP or DOWN keys to choose the desired
Channel Response Mode value for the selected channel.
4) Press the ENTER key, then repeat steps 1 and 2 to choose the Channel Response
Mode for any desired remaining channels.
5) Press the UP or DOWN keys to highlight NEXT, then press the ENTER key to open the
BIND to RX menu. NEXT will be highlighted.
6) Hold the Bind button down on the receiver, then turn the receiver ON. The Bind LED on the receiver will flash slowly. Release
the Bind Button. The Bind LED will continue to flash slowly.
7) Press the ENTER key. The NEXT command and the LED on the transmitter will begin to flash and the Bind LED on the
receiver will flash rapidly, then go out.
8) After the Bind LED on the receiver goes out, press the ENTER key a second time. Both the Bind LED on the receiver and the
LED on transmitter will illuminate solid, indicating that the Binding procedure is complete and the BASE SETTING menu
will open.
Changing the Base Setting Programming Values:
1) After completing the Binding process, the BASE SETTING menu will be open. Press
the UP or DOWN keys to highlight the desired Programming Option you want to
change for the ST (Steering), TH (Throttle), A1 (Auxiliary 1) or A2 (Auxiliary 2) channels.
2) Press the ENTER key, then press the UP or DOWN keys to choose the desired value
for the selected Programming Option.
3) Press the ENTER key, then repeat steps 1 and 2 to change the values for any remaining
Programming Options.
4) After making all your desired programming changes, press the UP or DOWN keys
to highlight FINISH, then press the ENTER key twice to finish the Setup Wizard. The
Setup Wizard will close and the STATUS screen will be displayed.
16
GENERAL