Key Assign Menu - AIRTRONICS MT-S User Manual

MT- S
Telemetry System with Sanwa Synchronized Link Support
2.4GHZ FH4T RADIO SYSTEM USER'S GUIDE
BIND MENU { BINDING, MODULATION TYPE AND CHANNEL RESPONSE MODE }
Changing the Channel Response Mode, Continued:
2) Press the ENTER key, then press the UP or DOWN keys to choose the desired
Channel Response Mode value for the selected channel.
3) Press the ENTER key, then repeat steps 1 and 2 to choose the Channel Response
Mode for any desired remaining channels.
BIND CHANNEL RESPONSE MODE setting range is NOR, SHR and SSR. The default setting is NOR.
The following Channel Response Modes are available:
NOR - Use with any brand of Analog or Digital servos (Slowest Response Time).
SHR - Use with any brand of Digital servos only (Faster Response Time).
SSR - Use with Airtronics or Sanwa Super Response SRG Digital servos only (Fastest Response Time) - FH4T Modulation Only.
WARNING: If you're using Analog servos in your model, DO NOT use the SHR or SSR Channel Response Modes for those
channels. Use the NOR Channel Response Mode with Analog servos. Using SHR or SSR Channel Response Modes with
Analog servos can result in poor performance or even damage to the servos.
SHR and SSR Channel Response Modes should only be used with Digital servos. While the SHR Channel Response Mode
can be used with any brand of Digital servo, the SSR Channel Response Mode should ONLY be used with Airtronics or
Sanwa Super Response SRG Digital servos.
Not all ESCs are compatible with SHR or SSR Channel Response Modes. If your ESC does not operate correctly, change the
Throttle Channel Response Mode to NOR.
SSR Channel Response Mode is only available when used with compatible FH4 or FH4T Super Response receiver.
When switching between SHR and SSR Channel Response Modes, your model's End Point Adjustment (EPA) settings may
be altered. In this case, you should double-check the EPA settings and readjust them if necessary.
Binding the Transmitter and Receiver:
To Bind the transmitter and receiver, please see the Transmitter and Receiver Binding section on page 18. Prior to Binding the
transmitter and receiver, make sure to choose the desired Modulation Type.
KEY ASSIGN MENU { KEY ASSIGNMENTS }
The KEY ASSIGN menu allows you to assign different functions to each of the three Auxiliary Switches and the three Trim
Switches. In addition, the ON/OFF behavior of some Auxiliary Switch functions can be changed. The Key Assignments function
also allows you to change the Direction of Travel and the Trim Resolution of the three Trim Switches. This allows you to
fine-tune the movement of the servos or programmed function when the Trim Switches are pressed.
Default Key Assignments:
Trm1 - Steering Trim
Trm2 - Throttle Trim
Trm3 - Steering Dual Rate
Sw1 - Timer ON/OFF
Sw2 - AUX1 (Channel 3)
Sw3 - AUX2 (Channel 4)
Auxiliary Switch (Sw3)
Auxiliary Switch (Sw1)
56
Trim Switch Trim Switch
(Trm2) (Trm1)
Trim Switch
(Trm3)
Auxiliary Switch (Sw2)
Section Continued on Next Page
SYSTEM
SYSTEM