Automatic Electrode Cleaning - Panasonic TK7585-SHK Instruction Manual

Automatic Electrode Cleaning/

This operation automatically removes the calcium deposits on the electrode plates inside the main unit.
After producing weak
acidic water
Whenever alkaline
ion water or weak
acidic water has been
produced 10 times
Whenever total run-
through volume of
alkaline ion water or
weak acidic water
reaches about 10 liters
When the Alkaline
Ionizer has not been
used for 24 or more
hours
Note
Water may drip or trickle from the main spout during
automatic electrode cleaning: this is normal and does
not indicate any trouble.
Even after the "Electrode cleaning" display has stopped
blinking, water may still come out of the drain outlet.
Automatic electrode cleaning is not performed while
the Continue lamp is lighted.
When the faucet
is turned off
When the faucet
is turned off
If, while the
Continue lamp is
lighted, the lamp
goes off
When alkaline
ion water or
purified water
runs through the
Alkaline Ionizer
Automatic electrode cleaning is
performed for up to 50 seconds
or so.
"Electrode cleaning" blinks on the LCD
display.
Water comes out of the drain
outlet, but do not use it.
Do not run water through the
Alkaline Ionizer during automatic
electrode cleaning.
Automatic electrode cleaning is not
performed while the timer is being
used.
Automatic electrode cleaning is
performed for about 15 seconds.
The buzzer beeps for about 3 seconds.
"Electrode cleaning" blinks for about
10 seconds.
Drain outlet
Do not turn off the water supply
until automatic electrode cleaning is
completed.
Do not use the water which comes out
of the main spout or drain outlet. Start
using it after the buzzer has beeped three
times.
Main spout
67