Panasonic TK7585-SHK Instruction Manual page 45

To sound the advisory buzzer when the amount to be measured is reached
1
Press the water quality selector
button corresponding to the water
quality that is to be selected.
2
With the faucet turned off, press
or
amount to be measured is reached.
The LCD display changes to the "Measure
setting" screen.
The water output amount which can be set
ranges from 0.6 to 5.0 liters.
Figures in a range from 0.6 to 2.0 liters can be
set in 0.2-liter increments.
Figures in a range from 2.0 to 5.0 liters can be
set in 0.5-liter increments.
(See table on the right.)
To stop the setting/
Press another control button or another water
quality selector button.
3
Open the faucet.
As soon as the "Preparation time" display is
cleared, the measurement begins.
4
When the advisory buzzer beeps,
turn off the faucet.
repeatedly until the
Setting range Display
Increased in
0.6 to 2.0
increments
liters
of 0.2
Increased in
2.0 to 5.0
increments
liters
of 0.5
Higher
LCD display
Example:
0.6 liter
The previously set figure is
displayed for the second and
subsequent times.
LCD display
▼
The advisory buzzer beeps when the
set amount is reached.
Note
If the faucet is not turned off even when the set amount is
passed, the measurement will continue and the water output
displayed. In this case, the water output buzzer will beep
once for each 0.2 liter of water output.
Display
Lower Reduced in
increments
of 0.2
Reduced in
increments
of 0.5
45