Panasonic TK7585-SHK Instruction Manual page 36

Operation (continued)
Using alkaline ion water, weak acidic water or purified water
When the "Reduce flow" display appears
(only while "Alkaline" or "Weak Acidic" is selected)
This message appears when too much water is
flowing (in which case, it may not be possible to
achieve a high enough pH level).
Gradually reduce the flow from the faucet
until the display is cleared
For "Alkaline": Flow of about 5.0 liters/minute
For "Weak Acidic":
Flow of about 3.2 liters/minute
Note
If the Alkaline Ionizer is used with the water
quality/application displayed, the flow will be
indicated while the "Reduce flow" message is
displayed. (This serves to provide a guideline
for the flow adjustment.)
When "Alkaline 4 (Strongly Alkaline)" is
selected, the "Reduce flow" message tends to
appear more often. (In this case, it is cleared
at a rate of about 2.2 liters/minutes.)
To find out what the pH level is
Measure the pH level using the supplied pH test kit. (See page 26.)
Note
The balance cartridge life is displayed when the flow drops (to less than 1.0 liter/min or so) because
the flow at the faucet has been overly reduced or because of changes in the tap water pressure.
(Electrolysis will be suspended if "Alkaline" or "Weak Acidic" is selected.) If one of the water quality
selector buttons is pressed in this status, the water quality is displayed for about 4 seconds, after
which the "Flow reduced" and "Too much tightened at the faucet?" displays appear alternately. To
use the Alkaline Ionizer again, open the faucet until the water quality display is restored.
To prevent the setting from returning to "Alkaline" after turning off the faucet
Refer to "How to set" (see page 56), and set "Alkaline priority" to "OFF".
"Alkaline priority" will be set to "OFF" for purified water only.
("Alkaline" is restored after producing Alkaline 4 (Strongly Alkaline) or weak acidic and turning off the
faucet.)
36
▼
.
(continued)
(Example)
When "Alkaline" is
selected
Displayed
alternately