For Your Operating Convenience; Measuring The Water Output Volume - Panasonic TK7585-SHK Instruction Manual

For Your Operating Convenience/

Measuring the water output volume/

Each time water is run through the Alkaline Ionizer, the total water output (amount of water that comes out of the
main spout) is calculated and indicated on the LCD display in 0.1-liter increments. (Water output display)
In measuring the water output, it is recommended that you set the main spout and acidic water spout as
instructed in the procedure on page 46 (in order to improve the accuracy of the water output display).
1 Turn off the faucet, and press
repeatedly until "Water
output" is displayed.
Each time the button is pressed, the display
on the LCD changes.
2
Press the desired water quality
selector button, and then turn on
the faucet.
As soon as the "Preparation time" display is
cleared, the measuring begins.
3
Measure the water output.
While the output is being measured, the
water output buzzer sounds once for
every 0.2 liters or so of water output.
4
Turn off the faucet when the water
output display reaches the figure
to be measured.
44
Example
Water output
display
Water quality selector buttons
Example
To turn off the water output buzzer
Refer to "How to set" (see page 55), and set "Water
output buzzer" to "OFF".
Important
If there is too large a discrepancy between the water
output display and actual water output, perform
"Correcting the water output display" (see page 48).