Panasonic TK7585-SHK Instruction Manual page 21

3
Screw in the outlet pipe until it is secured firmly.
Do not use any tools for this job (since the pipe may be damaged).
Ensure that the gasket is not twisted (since this may cause the water to leak).
Do not lift the unit by taking hold of the outlet pipe (otherwise damage may
result).
Caution label
Affix the label on
the main unit or at
an easily viewable
location near the
main unit.
Secure the acidic water
5
and drain hoses using the
suction disc.
Secure the hoses so that they will not
move out of place.
Note
If the hose is too long, it is recommended
that you cut it to the proper length (cut it
straight down).
Immediately after the Alkaline Ionizer has
been installed, "Preparation time" blinks
for about 20 seconds on the LCD display
when water is run through the Alkaline
Ionizer. (See page 9.)
The language of the LCD displays can be
selected from English or Chinese.
(See page 29.)
Gasket
6
Connect the power plug to
the power outlet
The buzzer sounds, about 15 seconds
later the LCD display lights up in blue,
and "
display.
The Alkaline Ionizer's power consumption
is 1 W even in the standby status.
Important
After installing the Alkaline Ionizer, run
alkaline ion water through the unit for
about 3 or 4 minutes to expel the air
inside the main unit.
The power plug is normally kept connected
to the power outlet (to keep the automatic
electrode cleaning function working).
LCD display
(AC 220V-240V).
" appears on the
21