Function Button Setting - Sony LMD-2451W Operating Instructions Manual

Submenu Setting
SUB PICTURE Sets the size of the sub picture. You can
SIZE (LMD- select from among 1 to 3. When the
2451W/2051W) setting is high, the size becomes large.

FUNCTION BUTTON SETTING

USER CONFIG – FUNCTION BUTTON SETTING
F 1 B U T T O N :
F 2 B U T T O N :
F 3 B U T T O N :
F 4 B U T T O N :
Submenu Setting
F1 BUTTON to F4 Assigns the function to the function
BUTTON buttons of the front panel and turns the
function on or off.
You can assign the function from among
SCAN, ASPECT, EXT SYNC, BLUE
ONLY, MONO, MARKER, H/V
DELAY, MULTI DISPLAY, CLOSED
CAPTION, APA and I/P MODE.
Factory setting
• F1 button: EXT SYNC
• F2 button: SCAN
• F3 button: ASPECT
• F4 button: H/V DELAY
About the function assigned to the
function button
SCAN
Press the button to change the scan size of the picture
according to the setting of "STANDARD" or
"FULL+NATIVE" selected in SCAN (page 68).
ASPECT
Press the button to set the aspect ratio of the picture, 4:3
or 16:9.
Note
The panel of LMD-2451W and LMD-2051W is 16:10
and the panel of LMD-1751W is 15:9.
When the 16:9 signal is displayed, black bars appear in
the upper and lower positions of the display. This is not
a malfunction. (See "Scan mode image" on page 69.)
EXT SYNC (external sync)
Press the button to operate the unit on an external sync
signal through the EXT SYNC IN connector.
EXT SYNC works when the component/RGB signals
are input.
72
Adjustment Using the Menus
xxxx
xxxx
xxxx
xxxx
BLUE ONLY
Press the button to eliminate the red and green signals.
Only blue signal is displayed as an apparent
monochrome picture on the screen. This facilitates
"chroma" and "phase" adjustments and observation of
VCR noise.
MONO
Press the button to display a monochrome picture. When
the buttons is pressed again, the monitor switches
automatically to color mode.
MARKER
Press the button to display the marker. Set the aspect
marker and safety area size in the MARKER SETTING
menu (see page 70).
H/V DELAY
Press the button to observe the horizontal and vertical
sync signals at the same time.
MULTI DISPLAY
Press the button to display the multi display. Set the
multi display setting in the MULTI DISPLAY
SETTING menu (see page 70).
CLOSED CAPTION
Press the button to display the closed caption. Set the
closed caption setting in the CLOSED CAPTION
SETTING menu (see page 73).
Not available for the signal input from BKM-227W.
APA (Auto Pixel Alignment)
Press the button to adjust the picture automatically to
maximum clarity for the signal input to the HD15 input
connector. For finer according to the input signal, see
"DOT PHASE" on page 67.
When the menu screen is displayed, the APA does not
function.
Note
If the APA operation does not finish correctly depending
on the input signal, adjust DOT PHASE (page 67).
I/P MODE
Press the button to set the delay by the picture
processing to the minimum level when interlace signal
is input. The mode switches in the sequence INTER-
FIELD t FIELD MERGE t LINE DOUBLER with
every press of the button (see "I/P MODE" on page 69).