User Config Menu; System Setting - Sony LMD-2451W Operating Instructions Manual

USER CONFIG menu

The USER CONFIG menu is used for setting the
system, marker, multi display, function button, closed
caption, audio and option.
USER CONFIG
S Y S T E M S E T T I N G :
M A R K E R S E T T I N G :
M U LT I D I S P L AY S E T T I N G :
F U N C T I O N B U T T O N S E T T I N G :
C L O S E D C A P T I O N S E T T I N G :
AU D I O S E T T I N G :
O P T I O N S E T T I N G :

SYSTEM SETTING

USER CONFIG – SYSTEM SETTING
M AT R I X :
C O M P O N E N T L E V E L :
N T S C S E T U P :
S C A N :
F O R M AT D I S P L AY:
L A N G U A G E :
P O W E R S AV I N G :
I / P M O D E :
B A C K G R O U N D :
Submenu
MATRIX
COMPONENT LEVEL
NTSC SETUP
68
Adjustment Using the Menus
xxx
xxxxx
x
xxxxxx
xx
E N G L I S H
xx
xxxxxxx
x
Setting
Applied to 480/60I or 480/60P
signal. Select 601 or 709.
Selects the component level from
among three modes.
• SMPTE: for 100/0/100/0 signal
• BETA0: for 100/0/75/0 signal
• BETA7.5: for 100/7.5/75/7.5
signal
Selects the NTSC setup level from
two modes.
The 7.5 setup level is used mainly
in North America. The 0 setup level
is used mainly in Japan.
Submenu Setting
SCAN Enables setting of the scan mode by
the button which the scan function
is assigned. Select from among
"STANDARD" and
"FULL+NATIVE". The displayed
picture differs according to the
selected mode (see "Scan mode
image" on page 69).
When STANDARD is selected
NORMAL scan (0% scan) and
OVER scan (5% over scan)
When FULL+NATIVE is selected
NORMAL scan, OVER scan,
FULL screen and NATIVE:
NATIVE is effective only when the
following signals are input.
LMD-2451W/2051W: 1080i,
1080P, 720P.
LMD-1751W: 1080i, 1080P, 720P,
480i, 575i, 480P, 576P.
1080P can be selected when BKM-
250TG is installed.
FORMAT DISPLAY Selects the display mode of the
signal format and scan mode.
• ON: The format and scan mode
• OFF: The display is hidden.
• AUTO: The format and scan
LANGUAGE Selects the menu or message
language from among seven
languages.
• ENGLISH: English
• FRANÇAIS: French
• DEUTSCH: German
• ESPAÑOL: Spanish
• ITALIANO: Italian
•
•
POWER SAVING Sets the power saving mode on or
off. When you set to ON, the
monitor goes into power saving
mode if no signal is input for about
one minute.
are always displayed.
mode are displayed for
about 10 seconds when the
input of the signal starts.
: Japanese
: Chinese