Vivax ACP-18CC50GEI User Manual page 283

button, to complete the save setting in COOL, DRY mode, and transfer to the save setting in
HEAT mode (There is no the function in cooling only unit), at this time, it displays the "SAVE",
"HEAT" icons, after setup has been completed, then press "FAN" +"▼" button last for 5 seconds,
and quit the SAVE setting operation. If the SAVE interface has been opened, the system will
respond to the last button input after 20 seconds, there is no any operation,the system will quit
the menu, and displays the normal unit off interface.
The above setting has been completed, the system will display "SAVE" icon, no matter
by buttons on displayer or the wireless remote control, the setting temperature should not
exceed the former SAVE setup temperature range, for example as show in Fig. 9, we set up
the cooling lower limit is 23℃ in SAVE setting,the upper limit is 27℃ , the user can set the
cooling temperature between 23℃ to 27℃ by the wireless remote control and buttons on
displayer.
If the set up upper limit temperature is the same with the lower limit temperature that the
system only can run at the corresponding modes at the set temperature.
After the SAVE mode set up, at unit turned off, press the "FAN" +"▼" buttons for 5 seconds,
will quit the SAVE setting function, but the former setting data will not clear, and the next time
SAVE setting will be the initial setting temperature.
After powered off, the SAVE setup function will be memorized, the next time power on, the
SAVE setting is still active.
Set up the SAVE mode, the SLEEP, AUTO modes will shield.
10) MEMORY function setup (Fig. 10)
At unit turned off, press "MODE" button for 10 seconds,
could switch whether turn on or off the unit state after
powered off, at setting temperature district displays 01,
denote that the unit is turned off after powered off, 02
denote that do not memorize the unit turn on or turn off,
press "ON/OFF" button quit setting. If the memory turn on
and off interface is displayed, the system will quit the
menu, the system will respond to the last button input after Fig 10
10