Vivax ACP-18CC50GEI User Manual page 282

7) Outer ambient temperature display (Fig. 8)
Under normal condition, "ENV" will display the room
ambient temperature, at unit turned on, or unit turned off
status, press "SWING" button last for 5 seconds, the
LCD will display "OUT ENV".
① If tested the outdoor temperature is the positive value, that
the setting temperature will not be displayed, the original
environment temperature displayer displays the system internal
tested outdoor environment temperature.
② If tested the outdoor temperature is the negative value, the
original environment temperature displays the system inner
tested the absolute value of the out environment.
After displayed the outdoor environment temperature 10 seconds
later, the system will back to the room ambient temperature
displaying surface.
NOTE: If the unit has been unconnected with the outdoor
ambient sensor, this function will be unavailable.
8) SAVE set up (Fig.9)
At unit turned off, to press the "FAN" +"▼" buttons continuously 5 seconds, adjust the Saver set
menu, at this time displays "SAVE" "COOL" icons, (if it is the first setup, that will display the
initial value:26℃), at the temperature setting district, it displays the lower limit temperature,and
the set temperature flashes, by pressing"▲"and"▼"buttons to set the cooling temperature lower
limit (the setting range is 16 30), press "ON/OFF" button to confirm; by pressing "▲" and"▼"
buttons to set cooling temperature upper limit, it will flash and display at ambient temperature,
( the setting range is 16-30) , and press "ON/OFF" button to confirm.
NOTE:The upper limit temperature should not be lower than the setting lower limit temperature.
If upper limit temperature is lower than the lower limit temperature, the system will default the
higher is the upper limit temperature, the lower is the lower limit temperature. Press "MODE"
Fig 8
Fig 9
9