Vivax ACP-18CC50GEI User Manual page 281

higher than the ambient temperature, the COOL mode will not start, only the fan is active.
★ In "DRY" mode, the "DRY" icon will light on. The inner fan will run at low fan speed in a
certain range.This DRY efficiency in this mode is more obvious than the one in COOL
mode, and the power saving efficiency is better.
★ In "HEAT" mode, the "HEAT" icon will light on. The setting temperature should be set up
higher than the present temperature; if it is lower than the present ambient temperature, the
HEAT mode is unavailable.
★ In "FAN" mode, the "FAN" icon will light on.
★ In "AUTO" mode, the " AUTO" icon will light on, according to the ambient temperature, the
unit will automatically adjust the running mode.
★ In "HEAT" mode, when the outdoor temperature is lower and high humidity, and it frosted
in outdoor unit, and the heating efficiency will be reduced. If it is in this case, the controller will
start defrosting automatically, and displays "DEFROST" icon.
NOTE: There is no HEAT mode in the cooling only unit, after the power saving set up, the
auto mode will be shielded.
6) TIMER setup (Fig. 7)
At unit turned off, the timer on could be set up, at unit
turned on, the timer off could be set up. After pressed the
"TIMER" button, the unit could be set up, and the
TIMER icon flashes, by pressing the buttons "▲","▼"
could increase or decrease the time of timer, when
repress the "TIMER" button, the Timer is valid, the units
will start calculate the time. When the unit is in the
TIMER, press the "TIMER" button could cancel the time.
NOTE:
When the protection or malfunction happens after the timer on was set up, the
time place will display the protection or the error codes, the timer button cannot be
setup, but the time you have setup before is still available.
Fig 7
8