Bulbs - HYOSUNG GT250 REi Owner's Manual

■ ■
REAR TIRE REPLACEMENT
1. Place the motorcycle on the jack or
block vertically.
CAUTION
Improper jacking may cause damage to
the frame or engine.
2. Loosen the rear axle ①.
❶
3. Carefully position a jack or block under
engine and raise until the rear wheel is
slightly off the ground.
WARNING
A hot muffler can burn you.
The muffler will be hot enough to burn
you for some time after stopping the
engine.
Wait until the muffler cools to avoid
burns.
4. Draw out the rear axle shaft.
5. Pull the rear wheel assembly rear
ward.
6. To replace the rear wheel, reverse the
complete sequence listed.
WARNING
Keep fuel and other flammable
substances away from electric
components.
Before changing a bulb, set the ignition
switch to position "OFF" and allow a few
minutes for the bulb to cool down.
Wear clean gloves or use a clean, dry
cloth to handle the new bulb.
Do not put your fingerprints on the bulb,
as this may lead to overheating and
failure.
If you have handled the bulb with bare
hands, clean it with alcohol to avoid any
damage.
DO NOT PULL ON THE WIRES.
N O T E
Before changing a bulb, check the fuses.
82

BULBS

CAUTION