HYOSUNG GT250 REi Owner's Manual page 90

⊙ ⊙ IGNITION SYSTEM CHECK
~ ~
1. Remove the spark plug and reattach it to
the spark plug lead.
2. Put the engine stop switch in the "
position and the ignition switch in the
"ON"position. Holding the spark plug
base firmly against the engine, the
transmission in neutral, the side stand
up, the clutch disengaged and push the
electric starter switch. If the ignition
system is operating properly, a blue
spark should jump across the spark plug
gap.
3. If there is no spark, clean the spark plug.
Replace it if necessary. Retry the above
procedure with the cleaned spark plug or
new one.
4. If there is still no spark, consult your
Hyosung dealer for repairs.
₩ ₩
&
Performing the spark test improperly
can be hazardous.
You could get a high voltage electrical
shock or an explosion if you are not
familiar with this procedure.
Do not perform this check if you are not
familiar with the procedure.
Keep the spark plug away from the
spark plug hole during this test. Do not
this test if you have a heart condition or
wear a pacemaker.
"
★ ★ ENGINE STALLING
1. Check the fuel supply in the fuel tank.
2. Check the ignition system for intermittent
spark.
3. Check the idle speed.
When occur any trouble, the best way is
to consult your Hyosung dealer for
repairs.
89
WARNING
CAUTION