HYOSUNG GT250 REi Owner's Manual page 38

⑤ ⑤
STARTER SWITCH
Use this switch to operate the starting
motor.
With the ignition switch in the "ON"
position, the engine stop switch in the
" " position, and the transmission is in
neutral, squeeze the clutch lever and the
side stand up and push the starter switch to
start the engine.
『
comes on for about three seconds
whenever the ignition switch is set to "ON"
position, and go off after three seconds.
In case of 『
necessarily the starter switch to start the
engine after go off the "FI" check lamp.
CAUTION
In case of 『 『
starter switch when "FI" check lamp
comes on, the engine will be started
badly and the spark plugs get wetted.
CAUTION
● ● Take off the starter switch right after
started.
● ● Do not engage the starting motor for
more than five seconds at a time as it
may overheat the wiring harness and
starting motor.
If the engine does not start after
several attempts, check the fuel
supply and igintion system.
(Refer for Page 88)
』 's "FI" check lamp
』 , push
』 』 , if push the
WARNING
The 『 『
are equipped with the side stand ignition
interlock system.
1. If the transmission is in neutral, you
can start the engine regardless of the
clutch lever and side stand.
2. If the transmission is not in neutral,
you can only start the engine with
pulling in the clutch lever and the side
stand up.
Make sure that the side stand igintion
interlock system is working properly
before riding.
37
』 』 & 『 『 』 』