HYOSUNG GT250 REi Owner's Manual page 67

⊙ ⊙ CHECK AND CLEAN OF
BATTERY TERMINAL
Clean the battery terminal when it is dusty
or rusted.
1. Set the ignition switch "OFF" position.
2. Remove the front seat.
3. Check that battery lead wire and
terminal.
4. If necessary : disconnect the negative
battery wire first, then disconnect the
positive battery wire.
Remove the battery.
5. Clean the terminal.
If there is white dust, clean it with warm
water.
6. Connect the battery wires and grease
the terminal lightly.
When reinstalling the battery, be sure to
connect the positive
then connect the negative
wire.
battery wire first,
battery
66
CAUTION
● ● Keep the battery away from fires.
● ● When disconnecting the battery wire,
be sure to remove the negative
battery wire first with the ignition
switch "OFF" position, then remove
the positive battery wire.
When reinstalling the battery, be sure
to connect the positive
wire first, then connect the negative
battery wire.
● ● Fasten certainly the battery wires.
● ● Incorrect installation of the battery
will reverse the terminal position
resulting in possible electrical
system damage due to incorrect
battery lead connection.
The red lead wire must go to the
positive terminal and the black (or
black with white tracer) lead wire
must go to the negative
● ● Never charge a battery while still in
the machine as damage may result
to the battery or regulator / rectifier.
battery
terminal.