HYOSUNG GT250 REi Owner's Manual page 34

⑪ ⑪ "FI"(Fuel Injection) CHECK LAMP
It comes on for about three seconds
whenever the ignition switch is set to
"ON" position with the engine stopped as a
test of injection system operation. The
check lamp must go off after three seconds.
If the electric fuel injection system fails,
the "FI" check lamp ⑪ comes on and the
LCD(Liquid Crystal Display) display panel
⑩ indicates "FI" letters in following two
modes ;
. The LCD display panel ⑩ indicates
A
"FI" letters and speedometer
alternately, and the "FI" check lamp ⑪
comes on and remains lit.
. The LCD display panel ⑩ indicates
B
"FI" letters continuously and the "FI"
check lamp ⑪ comes on and blinks.
The engine may continue to run in mode
, but the engine may not run in mode
A
.
B
CAUTION
Riding the motorcycle with the LCD
display panel indicating a problem with
electric fuel injection system and with
"FI" check lamp lit can damage the
engine and transmission.
Whenever the "FI" check lamp is lit and
the display panel indicates "FI" have
your authorized Hyosung dealer or a
qualified mechanic inspect the electric
fuel injection system as soon as
possible.
N O T E
If the LCD display panel indicates "FI"
letters and speedometer alternately, and
the "FI" check lamp comes on and
remains lit, keep the engine running and
bring your motorcycle to an authorized
Hyosung dealer.
If the engine stalls, try restarting the
engine after turning the ignition switch
off and on.
When the LCD display panel ⑩ indicates
"CHE", make sure that the engine stop
switch is in the "
If the LCD display panel still indicates
"CHE" after above procedure, inspect the
ignition fuse and connection of lead wire
couplers.
33
" position.