HYOSUNG GT250 REi Owner's Manual page 50

7. Before replacing the engine oil filter cap
⑥, be sure to check that the engine oil
④
filter spring
installed correctly. Use new "O" ring
each time the engine oil filter element is
replaced.
8. Replace the oil filter cap ⑥ and tighten
the nuts securely but do not over tighten
them.
9. Replace the drain plug and tighten it
securely. At this time, insert the gasket
necessarily.
10. Pour fresh engine oil through the
engine oil filler hole. Approximately
1,500 ㎖ of the engine oil will be
required.
CAUTION
Approximately 1,450 ㎖ ㎖ of engine oil
must be required when changing engine
oil only without replacing the oil filter.
CAUTION
In case of the engine oil pouring
excessively, the engine output being
made insufficient.
Be careful not to pour engine oil.
11. Install the engine oil filler plug.
CAUTION
Failure to use the correct oil can damage
your motorcycle.
Engine damage may occur if you use the
engine oil that does not meet Hyosung's
specifications.
Be sure to use the engine oil specified in
the FUEL AND OIL RECOMMENDATION
section.
⑤
and the "O" ring
12. Start the engine and allow it idle for a
few minutes. Check to see that no the
engine oil is leaking from the oil filter
are
cap and drain plug.
13. Check the oil level according to Engine
Oil Level Check procedure.
Engine oil leaks from around the oil filter
cap or drain plug indicate incorrect
installation or the "O" ring / gasket
damage. If you find any leaks or are not
sure that the oil filter cap / drain plug has
been properly installed, have the
motorcycle inspected by your Hyosung
dealer or qualified mechanic.
49
CAUTION