Bulbs - HYOSUNG GV250 Ei Owner's Manual

BULBS

WARNING
Keep fuel and other flammable
substances away from electric
components.
CAUTION
Before changing a bulb, set the ignition
switch to position "OFF" and allow a few
minutes for the bulb to cool down.
Wear clean gloves or use a clean, dry
cloth to handle the new bulb.
Do not put your fingerprints on the bulb,
as this may lead to overheating and
failure.
If you have handled the bulb with bare
hands, clean it with alcohol to avoid any
damage.
DO NOT PULL ON THE WIRES.
N O T E
Before changing a bulb, check the fuses.
INSPECTION OF LAMPS
Check if the head lamp, meter lamp, tail
lamp and license plate lamp work well
when the ignition switch is turned to the
"ON" position.
Check if the head lamp and meter lamp
work well when the ignition switch is
turned to the "ON" position.
And check if the tail lamp and license
plate lamp work well when the light
switch was operated.
Check if the brake lamp work well when
the front brak lever or rear brake pedal
was operated.
Check if the turn signal lamp work well
when the turn signal switch was
operated.
Check if the head lamp, tail lamp, turn
signal lamp and brake lamp are dusty or
damaged.
Brake / Tail lamp
79
Head lamp
Turn signal lamp
License
plate lamp
Turn signal lamp