HYOSUNG GT250 REi Owner's Manual page 79

Inspect every day in the following point at
the brake system.
①
Brake fluid leakage of the front and rear
brake system.
②
Leak or damage of the brake hose.
③
Operating of the brake lever and pedal.
④
Wear of the front and rear brake pads.
CAUTION
The front and rear brake system be
replaced the brake hose or the brake
fluid according to periodic inspection
chart by your authorized Hyosung
dealer for safety as in times of operating
at high pressure.
WARNING
Riding with worn brake pads will reduce
braking performance and will increase
your chance of having accident. Inspect
brake pad wear before each use. Ask
your Hyosung dealer or qualified
mechanic to replace brake pads if any
pad is worn to the limit.
WARNING
If brake pads were allowed to wear
down until uncovering the metal
substrate, metal-to-metal contact with
the brake disk would lead to rattle and
the brake caliper sparking ; this would
result in loss of braking and brake disk
damage, cousing a dangerous riding
conditions.
After replaced the front and rear brake
pads, squeeze/depress and release
several times the brake lever/pedal so
that it is setting at the original place.
Then, do not ride the motorcycle untill
operating the brake fluid and becoming
the brake distance.
WARNING
Replacing only one of the two brake
pads can be hazardous.
Replacing only one brake pads can
result in uneven braking action.
Replace both pads together.
⊙ ⊙ BRAKE DISK INSPECTION
Check the brake disk for damage or cracks.
⊙ ⊙ FRONT BRAKE FLUID SUPPLY
1. Place the motorcycle on a level surface
and keep the handlebars straight.
2. Clean the brake fluid reservior around not
to allow dust to get inside of it.
3. Loosen the screw and open the cap.
4. Replenish with brake fluid to the upper
line.
N O T E
The recommended brake fluid
78
CAUTION
: DOT3 or DOT4