HYOSUNG GT250 REi Owner's Manual page 52

CAUTION
● ● Take off the starter switch right after
started.
● ● Avoid pressing the starter switch
when the engine is running, or the
starting motor damage.
● ● Do not engage the starting motor for
more than five seconds at a time as it
may overheat the wiring harness and
starting motor.
If the engine does not start after
several attempts, check the fuel
supply and igintion system.
(Refer for Page 88)
⊙ ⊙ WHEN THE 『 『
STARTING :
『
on for about three seconds whenever the
ignition switch is set to "ON" position, and
go off after three seconds.
Push the starter switch to start the engine
after go off the "FI" check lamp.
● ● If push the starter switch when "FI"
check lamp "
engine will be started badly and the
spark plugs get wetted.
● ● If "FI" check lamp "
come on when the ignition switch is
set to "ON" position or fails to go out
after three seconds whenever the
ignition switch is set to "ON"
position, contact an authorized
Hyosung dealer.
51
』 's "FI" check lamp come
❶
❷
CAUTION
" ① ① comes on, the
" ① ① does not
』 』