Checks; Servicing; General Servicing - Valor 534 XAN Installation And Owner's Manual

16.3 Checks

•
A periodic check of the pilot and burner flames should be made. Check
after the fire has been on for at least 30 minutes. The pilot flame must
cover the tip of the thermocouple probe. The main burner flame pattern
will vary from appliance to appliance depending on the type of
installation and climatic conditions. See figures 63 & 64.
•
The appliance area must always be kept clear and free from combustible
materials, gasoline and other flammable vapors and liquids.
•
Inspect the vent terminal outdoors regularly to make sure that dirt, snow,
insects, leaves etc, do not obstruct it.
•
Examine the whole vent system regularly. We recommend annually.

16.4 Servicing

All appliances use four 1.5V AA batteries for thermostat control.
For Appliances with Wall switch only the batteries are accessible by opening
the bottom access panel.
For Appliances with Remote Control the batteries are accessible
by opening the bottom access panel and removing the lid of the
remote control receiver. The handset has a 9V battery.

16.5 General servicing

If you require any attention to your appliance, contact your
supplier quoting the model number. It will be helpful if the
appliance serial number can also be quoted. This is on the rating
plate, which is on a chained, plate accessible by opening the
bottom access panel.
The repair parts are shown in the separate repair parts leaflet.
Please always quote part number and description when
requesting spare parts.
Figure 63 Pilot flame
Figure 64 Main flames
33