TuffStuff SP-404 Assembly Instructions Manual page 3

1
60
FIG. 1 Using a rubber mallet, insert three Plastic End Caps 2 X 3
(#60) onto the tube-ends of the
surface, attach the Base Frame (#26)
Stack Frame (#1) using two Hex Head Cap Screws 1/2-13 X 3 1/2
(#20), four Flat Washers SAE 1/2" (#25), and two Nylon Insert Lock
Nuts 1/2-13 (#18).
Note: Use the overhead view on the cover page for designing
your layout before assembling.
5
5
12
FIG. 3 Carefully begin sliding the Weight Plates (#5) onto the
Guide Rods (#3), in position as shown above, allowing the first one
to rest on top of the Rubber Donuts (#12).
SP-404 Lat/Mid-Row
60
26
60
Base Frame (#26). Next, on a flat
to the assembled
3
12
4
FIG. 2 Remove the
Selector Bar (#6)
Weight
FIG. 4 Slide the
Rods (#3) allowing it to rest on top of the completed Weight Stack.
Note: Be sure the label on the
facing out, as shown above, before sliding the
lector Bar (#6)
Owner's Manual: Assembly Instructions
3
1
12
6
Guide Rod Retainer
to allow the assembly of the weight plates.
Label
6
3
5
Top Plate Selector Bar (#6)
Top Plate Selector Bar (#6)
onto the Guide Rods
(#4), and the Top Plate
onto the Guide
is
Top Plate Se-
(#3).
2