Toshiba Strata DK14 Programming Manual page 54

System & Station
Program 03 for DK424 – Flexible PCB Cabinet Slot Assignments
Program 03 for DK424 - Overview
Program 03 tells the system what type of optional PCBs are installed.
The Program 03 record sheet is the main record for the hardware configuration of the entire
system. It provides space to record station ports assigned to the station, Tie, and DID line PCBs
and line numbers assigned to the ground loop start, CO, Tie, and DID line PCBs.
Use the DK424 PCB Code table on
options. You must run Program 03 after installing PCBs with options such as OCA, RRCS, DIU,
etc. Also, run Program 03 for the slot of each new PCB when installing a new PCB in an existing
installation.
If universal PCBs are installed, Program 91-1 and 91-9 automatically assigns the appropriate PCB
codes to the installed slots. But, they do not assign option codes (such as OCA, PDIU, RRCS,
etc.).
CAUTION!
Important!
PIOU/PIOUS/RSSU
Codes 41, 42, and 43 assigns PIOU/PIOUS RSSU TTY port as Remote Maintenance, MIS for
ACD, and SMDI respectively; SMDR, Paging, Relay Control, and other miscellaneous options are
active on the PIOU/PIOUS that has the lowest number code (41, 42 or 43) in the system. Codes set
for RSIU/RSIS/RMDS in Program 76 have priority over codes 41, 42, and 43.
Piggyback PCB / Speaker OCA / Data Interface Unit Options
Run Program 03 to assign codes for all options except RCOS. Program 91-9 erases option codes
assigned with Program 03; Program 91-1 does not erase option codes already programmed. After
completing all Program 03 data entry, run Program 91-2 or cycle system power to transfer
Program 03 data into working memory.
3-8
Page 3-7
Running Program 91-9 erases Program 03 option codes; Program 91-1 does
not.
After completing Program 03 set the configuration in memory by running Program
91-2 or turn the base cabinet power supply switch off and wait five seconds before
turning it back on.
Expansion slots 7 and 8 can only be used if the following equipment is installed:
DK424 Base (with RCTUE/F and MBJU removed) and the DK424 Expansion.
See Chapter 4 – DK424 Configuration (Strata DK Installation and Maintenance
Manual) to determine PCB slot placement.
to determine the proper option code for PCBs with
Strata DK Programming 5/99