Connect The Cat5 Cable; Figure 7- Connect Speakers And Microphone To The Remote Unit; Figure 8- Connect The Cat5 Cable To The Remote Unit - Network Technologies ST-C5KVM2ARS-1000S Installation And Operation Manual

NTI XTENDEX Extenders

Figure 7- Connect speakers and microphone to the Remote Unit

Note: When two microphones are connected (one at local and one at remote), only one can be active at a time. See
mode charts on pages 12 and 13 for active microphone selection.

Connect the CAT5 cable

Make sure the CAT5 cable has been installed in accordance with
the "Preparation for Installation" instruction on page 3. Connect the
CAT5 cable to the "Cat 5" port on the Remote Unit. (See Fig. 8.)
When properly inserted the CAT5 cable end should snap into place.
Note: If an RJ45 wall outlet is being used, connect the other end
of the extension cable to the RJ45 wall outlet.
!
WARNING: Never connect the XTENDEX to an
Ethernet card, Ethernet router, hub or switch or other Ethernet
RJ45 connector of an Ethernet device. Damage to devices
connected to the Ethernet may result.
ST-C5KVM2A-1000S Remote Unit
Rear View
XTENDEX
Inc Technologies NTI
R
Network
Microphone
Stereo
Speakers
ST-C5KVM2ARS-1000S Remote Unit
Rear View
XTENDEX
Inc
R

Figure 8- Connect the CAT5 cable to the Remote Unit

10
Technologies NTI Network
CAT5 Cable to
Local Unit