Table of Contents
Advertisement
NTI XTENDEX Extenders
Plug-in and Boot Up
1.
Plug the power cord from the monitor into the power outlet.
Connect each AC adapter power connector to the 9VDC ports on the Remote and Local Units
2.
power outlet. The green LED on the RJ45 connector of both the Remote and Local Units should illuminate, indicating that a
proper power connection has been made to them.
Yellow Traffic LED
3.
Turn ON the CPU and Monitor.
Note: The yellow LED on each RJ45 connector will illuminate anytime data traffic is passing between the Local and
Remote Units, indicating proper CAT5 cable connection and communication. (See Fig. 9)
(See Fig. 9.)
Front View of Remote Unit
View of CAT5
connector
Green Power LED
Figure 9- Connect the AC adapter to the Remote Unit
They should each react as if they were directly connected to each other.
Barrel
Power Connector
9VDC @ 1.0A OUTPUT
(Outside
(Inside
barrel)
barrel)
2.1 mm x 5.5 mm Female
11
Plug each AC adapter into a
9 VDC
Adapter
ADAPTER
Advertisement
Table of Contents
