Icom ic-7300 Full Manual page 121

12
SET MODE
Function (Continued)
SPEECH Level
Sets the Voice Synthesizer audio output level.
• Range: 0 ~ 100%
[SPEECH/LOCK] Switch
Selects action.
SPEECH
• SPEECH/LOCK: Pushing
Synthesizer function.
Holding down
function ON or OFF.
• LOCK/SPEECH: Pushing
function ON or OFF.
Holding down
Voice Synthesizer function.
Lock Function
This function electronically locks
the panel display* to prevent setting changes by
accidental operation.
* Keys and dials are also locked except for
POWER
, , and
AF RF/SQL
• MAIN DIAL:
MAIN DIAL
MAIN DIAL
L
an item in the Set mode or Quick menu.
• PANEL: The panel operation is disabled.
Memo Pmd Qumntity
Sets the number of memo pad channels.
• 5: 5 channels.
• 10: 10 channels.
MAIN DIAL Auto TS
Sets the Auto Tuning Step function for
When rapidly rotating
MAIN DIAL
automatically changed according to the rotation speed.
• OFF: Auto tuning step is turned OFF.
• LOW: Approximately 2 times faster.
• HIGH: Approximately 5 times faster when the tuning
step is set to 1 kHz or smaller steps.
Approximately 2 times faster when the tuning
step is set to 5 kHz or larger steps.
MIC Up/Down Speed
Sets the response speed of [∫]/[√] on the supplied
microphone while holding down.
• Slow: Slow speed (25 tuning steps/second).
• Fast: Fast speed (50 tuning steps/second).
(Default: 50%)
(Default: SPEECH/LOCK)
turns ON the Voice
SPEECH
turns the Lock
SPEECH
turns the Lock
SPEECH
turns ON the
SPEECH
(Default: MAIN DIAL)
or
MAIN DIAL
AF RF/SQL
.
SPEECH
is disabled.
functions only when selecting
(Default: 5)
(Default: High)
MAIN DIAL
, the tuning step is
(Default: Fast)
Quick RIT/∂TX Clemr
Selects the operation of
functions.
• OFF: Clears when
second.
• ON: Clears when
[NOTCH] Switch (SSB)
[NOTCH] Switch (AM)
Selects the notch function used in the SSB or AM
mode.
• Auto:
• Manual:
• Auto/Manual: Both the Auto and Manual notch filters.
SSB/CW Synchronous Tuning
Turns the Displayed Frequency Shift function ON or
OFF.
,
This function automatically shifts the frequency to
match the CW pitch when the operating mode is
toggled between SSB and CW.
• OFF: Stays on the frequency even when the
operating mode is toggled between SSB and
CW.
• ON: Shifts the frequency when the operating mode
is toggled between SSB and CW, to keep
receiving the signal.
CW Normml Side
Selects the carrier point in the CW normal mode.
• LSB: The LSB side.
.
• USB: The USB side.
12-6
for the RIT and ∂TX
CLEAR
is held down for 1
CLEAR
is pushed.
CLEAR
(Default: Auto/Manual)
(Default: Auto/Manual)
Only the Auto notch filter.
Only the Manual notch filter
(Default: OFF)
(Default: OFF)
(Default: LSB)