3-13 Installation
3-13-3 Paper Roll Installation (SPS-520)
1. Open the cover printer.
2. Push the Orange Cap Lever toward the rear of the printer and lift up to open the paper cover.
3. Ensure that the paper is being fed from the bottom of the roll. Place the roll into the concave bottom of the
printer. And put the leading edge of the paper over the printer in Figure3-3-①.
4. Close the printer cover slowly until it locks firmly.
5. Tear off the excess paper.
3-13-4 Paper Roll Installation(SPS-530)
1. Open the cover printer.
2. Pulling the Orange Lever will open paper cover in Figure3-2-①.
3. Ensure that the paper is being fed from the bottom of the roll. Place the roll into the concave bottom of the
printer. And put the leading edge of the paper over the printer in Figure3-2-②.
4. Close the printer cover slowly until it locks firmly.
5. Tear off the excess paper.
SAM4S SPS-500 Series
Figure 3-2 Paper Installation (SPS-530)
3 Installation and Operation
3-43