Insert Tools, Accessories; Technical Data - Hilti SCW 70 Original Operating Instructions

3 Insert tools, accessories

Accessories for the SCW 70
Designation
Parallel guide (rip fence)
Guide rail
Guide rail adapter
Recommended saw blade for the SCW 70
Designation
Saw blade
Recommended saw blade for the WSC 7.25-S
Designation
Saw blade

4 Technical data

Right of technical changes reserved.
Rated voltage 100 V
Rated power input 1,430 W
Rated current input 15 A
Mains frequency 50...60 Hz
NOTE
This equipment complies with the applicable standard provided that the maximum permissible mains supply impedance
(Zmax) at the point where the user's installation is connected to the public supply network is less than or equal to
0.370+j0.25 Ω. It is the responsibility of the installer or user of the equipment to ensure, by consultation with the supply
network operator if necessary, that the equipment is connected only at a point in the supply with an impedance of less
than or equal to Zmax.
Power tool
Weight in accordance with EPTA
procedure 01/2003
Supply cord length
Dimensions (L x W x H)
Base plate
Maximum saw blade diameter
Minimum saw blade diameter
Saw blade disc thickness
Kerf width
Saw blade arbour size
Cutting depth
Speed under no load
NOTE
The vibration emission level given in this information sheet has been measured in accordance with a standardized test
given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment
Description
WGS 1400‑2B
Short designation
W-CSC 190x30 z24 A
Short designation
W-CSC 7 ¹⁄₄x⁵⁄₈ t24 GP
110 V
1,550 W
15 A
50...60 Hz
SCW 70
5.3 kg
2.5 m
317 mm x 236 mm x 269 mm
290 mm x 170 mm
190 mm
184 mm
1.1...1.5 mm
1.7...2.3 mm
30 mm
Cutting angle 0°: 67 mm
Cutting angle 45°: 49 mm
Cutting angle 56°: 38 mm
5,800/min
220 V 230‑240 V
1,700 W 1,700 W
8.1 A 7.5 A
50...60 Hz 50...60 Hz
WSC 7.25‑S
5.3 kg
2.5 m
317 mm x 236 mm x 269 mm
290 mm x 170 mm
190 mm
184 mm
1.1...1.5 mm
1.7...2.3 mm
15.88 mm (⁵⁄₈")
Cutting angle 0°: 64 mm
Cutting angle 45°: 47 mm
Cutting angle 56°: 37 mm
5,800/min
en
17