SCW 70/ WSC 7.25‑S circular saw In these operating instructions, the designation “the It is essential that the operating instructions power tool” always refers to the SCW 70 / WSC 7.25 are read before the power tool is operated for circular saw.
Sawing metals is not permissible. Do not use the power tool to cut tree branches or logs. To avoid the risk of injury, use only genuine Hilti accessories and insert tools. Observe the information printed in the operating instructions concerning operation, care and maintenance.
Page 7
Operating instructions Hexagon socket wrench Parallel guide (rip fence) Hilti cardboard box or toolbox 2.7 Using extension cords Use only extension cords of a type approved for the application and with conductors of adequate cross section. The power tool may otherwise lose performance and the extension cord may overheat. Check the extension cord for damage at regular intervals.
Noise and vibration information for the SCW 70 / WSC 7.25-S (measured in accordance with EN 60745-2-5): Typical A-weighted sound power level...
Page 10
tached to a rotating part of the power tool may result 5.2 Safety instructions for all saws in personal injury. 5.2.1 Cutting procedures e) Do not overreach. Keep proper footing and bal- ance at all times. This enables better control of the DANGER power tool in unexpected situations.
Page 11
not in line with the blade. Kickback could cause the path. Be aware of the time it takes for the blade to saw to jump backwards, but kickback forces can be stop after switch is released. controlled by the operator, if proper precautions are taken.
Hilti for wood dust ing. This helps to avoid tripping over the cord while and/or mineral dust together with this tool. Ensure working.
Page 13
Release the cutting depth adjustment clamping lever 6.1 Changing the saw blade The set cutting depth is indicated by the arrow on the scale on the gear housing. Lift the power tool in a scissor movement and set the desired cutting depth by closing the clamping lever.
Page 14
Push the saw steadily across the workpiece. The parallel guide can be fitted on either side of the base The pendulum guard opens as it contacts the ac- plate. tuating edge at the side of the guide rail and sub- sequently closes at the end of the rail as the cut is 6.6 Fitting / adjusting the parallel guide 6 completed.
Do Have the power tool repaired by Hilti Service. not use a spray, steam pressure cleaning equipment or running water for cleaning. This may negatively affect the 7.5 Checking the power tool after care and...
Clean out the chip ejector channel. 9 Disposal Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back your old power tools or appliances for recycling.
Need help?
Do you have a question about the SCW 70 and is the answer not in the manual?
Questions and answers