50 Hz System Controller And Peripheral Cabinet Power Cord Configurations; 60 Hz Printer Outlet Voltages - Xerox 4635 Installation Planning Manual

50 Hz system controller and peripheral cabinet power cord configurations

60 Hz printer outlet voltages

XEROX 4635 LASER PRINTING SYSTEM INSTALLATION PLANNING GUIDE
Figure 3-12 shows the 50 Hz system controller power cord
configuration.
Figure 3-12.
200/2300 VAC
0 VAC
Note that 50 Hz plug and receptacle specifications vary
according to local codes.
Note: All power outlets must have a dedicated circuit for each
system equipment piece. Ensure that each power cord has a
separate circuit.
Refer to table 3-12 for the 60Hz voltage requirements at the
power outlet.
Table 3-12.
Service outlet
configuration Measurement
4 Wire Line 1 to Neutral
4 Wire Line 2 to Neutral
4 Wire Neutral to Ground
4 Wire Line 1 to Line 2
4 Wire Line 1 to Line 2
System controller and peripheral cabinet power
cord 50 Hz installation 200/230 VAC, single
phase, 15A
NEUTRAL
BLUE
BROWN
LINE
200/2300 VAC
GREEN/YELLOW TRACER
GROUND
Printer (50 Hz) voltage requirements at power
outlet
Nominal
120 V RMS
120 V RMS
0
208 V RMS
240 V RMS
PREINSTALLATION
Range
107-127 V RMS
107-127 V RMS
0-10 V RMS
182-220 V RMS
210-254 V RMS
3-19