Xerox 4635 Installation Planning Manual page 21

Processor feeder trays
High-capacity feeder
High-capacity stacker
Printer control console
XEROX 4635 LASER PRINTING SYSTEM INSTALLATION PLANNING GUIDE
Two processor feeder trays are located in the main part of the
printer:
•
•
Inverter The inverter is part of the inverter feeder/stacker module. It
allows for proper collation of the print job. It also directs printed
output to the sample tray, when required.
There is a high-capacity feeder (HCF) tray located in the bottom
half of each feeder/stacker module.
Each HCF tray can hold up to 2600 sheets of 20 pound/75 gsm
paper.
There is a high-capacity stacker (HCS) bin located in the top half
of each feeder/stacker module.
Each HCS bin can hold up to 2500 sheets of 20 pound/75 gsm
paper. Paper can be stacked directly onto the HCS pallet or into
a specially-designed container. Stacking capacity is approximately
100 to 150 sheets less when stacking into a container.
Sample tray The sample tray located on top of the printer holds up to 100
sheets of paper. Output such as transparencies and sample
prints of fonts or forms are sent to the sample tray.
Purge tray The purge tray is located on top of the feeder/stacker module.
Aborted sheets (for example, damaged sheets or sheets cleared
after a paper jam) are sent to this tray. The purge tray can hold
up to 100 sheets of paper.
The printer control console is the color monitor located on top
of the printer. It contains message areas and graphic displays
that alert you to paper jams and other fault conditions, such as
low toner. The printer control console also contains buttons
which allow you to control certain functions of the printer (for
example, continuing an interrupted job) without returning to the
PC UI or terminal.
Attention light An attention light is mounted on top of the inverter module.
The attention light signals when the printer requires operator
attention.
Attention alarm The attention alarm sounds when the printer requires operator
attention. The alarm may be disabled by the operator.
The main tray (tray 1) holds up to 1100 sheets of 20
pound/75 gsm (grams per square meter) paper.
The auxiliary tray (tray 2) holds up to 600 sheets of 20
pound/75 gsm paper.
LPS OVERVIEW
1-5