Space Planning Guidelines; Clearance Space Requirements; Shared Space - Xerox 4635 Installation Planning Manual

Space planning guidelines

Clearance space requirements

XEROX 4635 LASER PRINTING SYSTEM INSTALLATION PLANNING GUIDE
Your 4635 LPS must be installed in a fixed location and have:
• 36 inches/914 mm of clearance on all sides of each
component, including any finishers or feeders you have
attached to your 4635 LPS. 50 inches/1270 mm clearance is
required at the front of the printer
• 78 inches/1981 mm of vertical clearance throughout the
entire area
• 24 inches/610 mm of exclusive operator area in front of each
component.

Shared space

It is always best to provide the full amount of clearance space
around your LPS. It is sometimes necessary, however, to have
shared space between components, such as between the printer
and the system controller, or between the 4635 LPS and another
printing system. It is possible to share the 36-inch/914-mm
clearance space around each component, but there are three
rules which must always be observed:
• Space may be shared only with other Xerox equipment.
• Components may share the 36-inch/914-mm general service
clearance areas, but they may not share the 24-inch/61-mm
operator area in front of each component.
• There must be 78 inches/1981 mm of vertical clearance
throughout the entire area.
Note: Finishers attached to your bypass transport and feeders
attached to your 4635 LPS through the input enablement device
may occupy shared space with Xerox equipment. However, they
must meet the Xerox DFA Level 1 specifications and be
removable to allow servicing of the 4635 LPS feeder/stackers.
Consult with your Xerox or Rank Xerox representatives to ensure
all the requirements are met.
PREINSTALLATION
3-7