Dry Ink (Toner); Fuser Agent; Developer; Tapes - Xerox 4635 Installation Planning Manual

Dry ink (toner)

Fuser agent

Developer

Tapes

XEROX 4635 LASER PRINTING SYSTEM INSTALLATION PLANNING GUIDE
grain should be parallel with the long side (long-grain) for the
most reliable feeding and stacking. Purchase long-grain paper.
Keep these points in mind when preparing your paper storage
area:
• Store paper in its own wrapper; do not leave it unwrapped or
where it can be damaged by dampness or heat.
• Store paper on a flat surface and not on its side or edge.
• Always store in a cool, dry area.
• Store on pallets or shelves, not on the floor.
• Before use, paper should spend at least one day in the same
area as the printer to allow environmental stabilization.
Dry ink (also referred to as "toner") is the black powder which
forms the image on the printed page. There are three cartridges
of dry ink in each container. Keep an adequate supply on hand
at all times. The operator can change throw-away cartridges
easily with no mess. Use only dry ink that is specified for use in
your LPS. (Refer to the consumable supplies table at the end of
the "Postinstallation" chapter.)
Note: For a 4635MX system use only dry ink specifically
designed for that system.
Fuser agent is a consumable item required by the LPS. Keep an
adequate supply on hand for installation by the Xerox or Rank
Xerox service representative.
Developer is a required item that needs to be ordered and kept
on hand. It is changed by a Xerox or Rank Xerox service
representative. Use only developer specified for use in your LPS.
(Refer to the consumable supplies table at the end of chapter 5.)
Each of the tape drives available on the 4635 LPS requires a
different tape format.
The 1/4-inch QIC tape drive uses quarter-inch stream cartridge
tapes. The tape data capacity should be 320 MB with 225
KB/second data transfer rate.
The optional 18-track tape drive uses 0.5-inch IBM 3480-
compatible cartridge tapes with a data capacity of 200 MB.
Cartridges are not available from Xerox.
The optional 9-track tape drive supports reel-to-reel 9-track 1600
bpi (PE) and 6250 bpi (GCR) encoded magnetic tapes.
PREINSTALLATION
3-25