Mitsubishi Electric FR-D720-008 Instruction Manual page 36

NICHIFU Co.,Ltd.
Bar terminal product
2
Wire Size (mm )
0.3 to 0.75
3) Insert the wire into a socket.
When using a stranded wire without a bar terminal, push an open/close button all the way down with a flathead screw
driver, and insert the wire.
Note
When using a stranded wire without a bar terminal, twist enough to avoid short circuit with a nearby terminals or
wires.
Place the flathead screwdriver vertical to the open/close button. In case the blade tip slips, it may cause to damage of
inverter or injury.
Wire removal
Pull the wire with pushing the open/close button all the way down firmly with a flathead screwdriver.
Note
Use a small flathead screwdriver (Tip thickness: 0.4mm (0.02 inch)/tip width: 2.5mm (0.10 inch)).
If a flathead screwdriver with a narrow tip is used, terminal block may be damaged.
Introduced products :(as of Sep., 2008)
Product
Flathead screwdriver
Place the flathead screwdriver vertical to the open/close button. In case the blade tip slips, it may cause to damage of
inverter or injury.
Insulation product number
number
BT 0.75-11
Open/close button
Open/close button
Type
SZF 0- 0,4 x 2,5
Control circuit specifications
Bar terminal
crimping tool
VC 0.75 NH 67
Flathead screwdriver
Flathead screwdriver
Maker
Phoenix Contact Co.,Ltd.
2
25