Communication Eeprom Write Selection (Pr. 342) - Mitsubishi Electric FR-D720-008 Instruction Manual

4.19.4 Communication EEPROM write selection (Pr. 342)

When parameter write is performed from RS-485 comuunication with the inverter PU connector, parameters storage
device can be changed from EEPROM + RAM to RAM only. Set when a frequent parameter change is necessary.
Parameter
Name
Number
Communication EEPROM
342
write selection
The above parameter can be set when Pr. 160 Extended function display selection = "0". (Refer to page 160)
When changing the parameter values frequently, set "1" in Pr. 342 to write them to the RAM only.
The life of the EEPROM will be shorter if parameter write is performed frequently with the setting unchanged from "0 (initial
value)" (EEPROM write).
REMARKS
When "1" (write to RAM only) is set in Pr. 342, powering off the inverter will erase the changed parameter values. Therefore, the
parameter values available when power is switched on again are the values stored in EEPROM previously.
Communication operation and setting
Initial Value Setting Range
0
0
1
Description
Parameter values written by communication are
written to the EEPROM and RAM.
Parameter values written by communication are
written to RAM.
4
185