Chapter 3 Installing Nec 1765 Software; Overview; Using Silentwriter Software With The Silentwriter 1765; The Windows Pcl 5E Driver - NEC Silentwriter 1765 Configuration Manual

I
N S T A L L I N G

Overview

This chapter describes how to install NEC 1765
Administration and Client software. It contains the
following sections.
• Using Silentwriter Software with the
Silentwriter 1765
• NEC 1765 Software
• Installing NEC 1765 Software for NetWare
• Installing NEC 1765 Software for TCP/IP
• Installing NEC 1765 Software for AppleTalk
NEC 1765 S
Using Silentwriter Software with the
Silentwriter 1765
This chapter assumes you have already installed the
Silentwriter Printing System and drivers as described in
Chapter 2, "Using Silentwriter Software," of the User's
Guide.
The Printer Setup software, which allows you to specify
which printer options have been installed,
communicates with the Silentwriter through the parallel
cable. If you connect your Silentwriter to the network
using Ethernet cable please make note of the following.

The Windows PCL 5e Driver

This printer driver cannot sense installed options across
the Ethernet. All printer options will be enabled
whether they are actually installed or not. To avoid
unexpected output, make sure you choose output
options that are actually installed.

The Windows PostScript Driver

The PostScript driver assumes that all options have
been installed. In order to direct output to specified
printer options you must configure the PostScript driver
manually using the PostScript printer driver as
described in Chapter 2 of the User's Guide. Be sure to
deselect any option that is not installed.
O F T W A RE
3
3–1