Enable The Remote Printer; Enable The Remote Printer If The Print Server Resides On A File Server (Nlm Print Server); Enable The Remote Printer If The Print Server Resides On A Workstation (Dedicated Dos Print Server); Enable The Remote Printer If It Is Connected To A Workstation With A Parallel Cable - NEC Silentwriter 1765 Configuration Manual

Enable the Remote Printer

If you selected Remote Printer mode, you must also
enable the Remote Printer server in order to print
documents. The steps to enable the Remote Printer
server depend on where the print server resides. For
printers connected in Network Printer mode, the LAN
card is the print server.
Enable the Remote Printer if the Print Server Resides on a
File Server (NLM Print Server)
At the NetWare File Server Console, type the command
load PSERVER <print server>
where <print server> is the print server you defined in
step 8 on page 4-8. In this example, the defined print
server is NP_015446 and the command is
load PSERVER NP_015446
Enable the Remote Printer if the Print Server Resides on a
Workstation (Dedicated DOS Print Server)
1. At the workstation login to the file server as a
supervisor.
2. Type the following commands.
cd f:\public
f:\public\pserver.exe <print server>
where <print server> is the print server you defined
in step 8 on page 4-8. In this example, the defined
print server is NP_015446 and the commands are
cd f:\public
f:\public\pserver.exe NP_015446
Enable the Remote Printer if it is Connected to a
Workstation With a Parallel Cable
1. From the print server workstation, switch to
MS-DOS and run RPRINTER for NetWare 3.1x or
NPRINTER for NetWare 4.1.
2. Select the name of the print server you defined in
step 8 on page 4-8. In this example, the defined print
server is NP_015446.
NetWare with PCONSOLE 4–11