Table of Contents
Advertisement
Install TCP/IP Protocol on Windows 95
The Windows 95 network configuration depends on the
TCP/IP network software, which is included with
Windows 95. Before you begin you need to know the IP
address for your workstation. You also need the subnet
mask. Check with your system administrator for this
information. Follow these steps to install TCP/IP.
1.
From Windows 95 open the control panels. (Select
the Start menu, then the Settings submenu, then the
Control Panel menu option.)
2.
Open the Network control panel.
3.
Select the Configuration tab in the Network control
panel.
4.
See if TCP/IP is listed as one of the installed
network components. If TCP/IP has already been
installed proceed to step 8.
5.
In the Configuration panel click the Add button.
6.
In the Select Network Component Type dialog box
select Protocol and click the Add button.
7.
In the Select Network Protocol dialog box select
Microsoft from the Manufacturers list, then select
TCP/IP from the Network Protocols list. Click the
OK button.
8.
In the Configuration panel of the Network control
panel, select TCP/IP from the Network Components
list. Click the Properties button.
9.
If your network supports ARP, click Obtain an IP
address automatically in the TCP/IP Properties
dialog box. If your network does not support ARP
click Specify an IP address and enter the IP address
and subnet mask.
10. Click the OK button to close the TCP/IP Properties
dialog box.
11. The System Settings Change dialog box asks if you
want to restart your computer. You must restart for
the changes to take effect. Click the Yes button to
restart.
4–22
1765 Network Printer Configuration Guide
Verify Printer Driver Installation
You should have installed the printer drivers as you
completed the steps described in the Easy Printer Setup
Guide. Follow these steps to verify that the printer
drivers have been installed correctly.
1.
From Windows 95 open the control panels. (Select
the Start menu, then the Settings submenu, then the
Control Panel menu option.)
2.
Open the Printers control panel.
3.
The printer drivers are represented by two icons
labeled "NEC Silentwriter 1700 Series" and "NEC
1700 Series PostScript L2." If these icons are not
visible see Chapter 3 in the Easy Printer Setup Guide.
Advertisement
Table of Contents
