Restarting The System - NEC IP8800/S2400 Series Troubleshooting Manual

7.

Restarting the System

7.1 Restarting the System
7.1.1 Restarting the System
The system can be restarted by using the reload command. Log is stored at restart time. For input format and
parameter of the command, see the manual "Operation Commands."
IP8800/S6700, IP8800/S6600, and IP8800/S6300
The following is an example showing how to select the parameter of the reload command when "restarting the
standby system" and collecting the CPU memory dump of BCU, CSU, and MSU according to the confirmation
message.
Step1
Select whether to restart or stop the system.
Figure 7-1: Selecting Restart/Stop of the System
Restarting the
Parameter to input
As the standby system is restarted in Step 1, no parameter is selected as shown in figure above.
Step2
Next, select whether to collect the dump.
Figure 7-2: Selecting CPU Memory Dump Type
memory dump
Parameter to input
dump-image
dump-image
160
Select restart or
stop
Stopping the
system
system
None Stop
Select whether to collect
Collecting
Not collecting
memory dump
no-dump-image
memory dump
Checking
memory dump
collection
None
Not checking memory
dump collection
Collects memory dump
when neither (checking/
not checking) is selected
-f