NEC IP8800/S2400 Series Troubleshooting Manual page 35

■ Do not touch a working (including immediately after stopping) SFP-T.
• A working (establishing a link) SFT-P can have up to 65
or immediately after stopping to prevent getting burned.
Caution. Hot! (all sides)
• To remove an SFP-T, follow the following procedures. Otherwise, you may get burned.
• To remove an SFP-T without turning off the device, execute the inactivate command, and remove the SFP-T
five minutes later.
• To remove an SFP-T from the device turned off, power off the switch of the device, and remove the SFP-T five
minutes later.
• An SFP-T has the following label attached.
■ Lithium battery
• This device mounts a lithium battery for the real-time clock. If the lithium battery is inadvertently handled, a
personal injury or fire may be caused as a result of heat generation, burst, or ignition. Do not remove the lithium
battery from the device or disassemble it, heat it to 100
■ Cleaning
• Remove dust on and around the device on a regular basis. Device shutdown and fire disasters or electric shock
may be caused.
° °
C/140 F in temperature. Do not touch it when working
° °
C/212 F or higher, burn it, or wet it with water.
Safety Guide [IP8800/S6600]
xxv